Spectrum z510 user manual

Previous Page. Next Page. Page 3 External keyboard and monitor manufacturing Window 7. Page 4 Pull all the binder tubes loose from the septa. Note- make sure you have your paper towels handy. When the tubes are pulled from the septa, binder will leak from the tubes.

Page 5 Old septum shown with the four plastic washers that must be re-installed on new septa before installation. Septum being removed. Note — The plastic washer tends to stick to the carriage. Do not lose them. Page 6 Some carriages may have the yellow tube going under the clear.

If so, please re-route at this time. Page 7 Re-install the Fast axis module and pull several syringes of binder through the septa to clear all air bubbles. Re-install the print heads purge if new heads Run an auto- alignment.

Page 8 Remove the two hex screws that mount the assembly into place. Note — The ZPrinter and ZPrinter use the same wiper assembly, and the mounting screws and method is the same. Page 9 Clean the holes from both sides. Align the rubber wiper with the holes in the squirter block and wrap around the block. This should be a visual indication that the pressure is even on the two screws and the assembly is tightened enough. Return power cord to system, power up the system.

Page 11 reading ml to the chart. Three-dimensional printing enables making of foundry moulds for elements of complex shapes. The mould presented in the paper was printed with the use of Z Spectrum unit in the Car Technology Sp.

The basic material for printing foundry moulds is the ZCast powder. This powder is a mixture of traditional molding sand, gypsum and supplementary ingredients. The mould is made in ZCast technology, and it enables casting of zinc, magnesium and aluminum alloys at max. The paper describes research on the possibility to utilize a standard ZP14 powder for building a rotor blade casting moulds.

The research has showed that the ZP14 powder may serve for printing foundry moulds, which should then be subjected to thermo-chemical treatment. Application of the basic ZPrint system powder permits a reduction in mould manufacturing costs. Opis fizyczny. Myszka, J. Modzelewski, M. Haratym, J. Feriera, E. Santos, H. Madureira, J. Shigley, Ch. Mischke, T.